Exercise 8D: Your coast in 2100
Pages: NASA's Sea Level Projection Tool (sealevel.nasa.gov/ipcc-ar6-sea-level-projection-tool), which shows the IPCC's sea-level projections, and NOAA's Sea Level Rise Viewer for US coasts (coast.noaa.gov/slr), both listed on the site's Models and Data page, https://simpleserioussolvable.org/models/
Chapter: 8, "Future Climate Change" (section 8.6), with Chapter 6's sea-level record
Time: about 50 minutes
The question
Figure 8.10 shows the global sea rising by roughly half a meter to a meter by 2100, depending on our emissions. But nobody lives at the global average. How high will the sea rise where you'd stand on the shore, what will raise it, and why won't it stop in 2100?
What to do
NASA's tool shows the projections of the IPCC's Sixth Assessment Report for the whole world and for tide gauges along the world's coasts: the instruments that measure sea level at the shore, some of them for more than a century. Every number is the rise above the average sea level of 1995–2014. The first number in each cell is the median; the two in brackets are the likely range. The tool works on a phone, but its tables need a sideways swipe, so a computer is easier. Use SSP1-2.6 for a low-emissions future and SSP3-7.0, the Regional Rivalry scenario that Chapters 7 and 8 follow, for a high one.
- Open the tool. Open NASA's Sea Level Projection Tool (sealevel.nasa.gov/ipcc-ar6-sea-level-projection-tool). Click "Start", then "Got it".
- The whole world. Click "View global projection" at the bottom of the panel on the left. Check that "Units" says Metric. Scroll down to "Projected Sea Level Rise", a table of what each part of the climate system adds in the year chosen under it (2100 to begin with). Under it, "Summary of Projected Totals and Rates" gives the totals for several years and the rate of rise, in millimeters a year, for 2040–2060 and 2080–2100. For SSP1-2.6 and SSP3-7.0, write down the total in 2100 and in 2150, both rates, and the largest single part in 2100.
- Manila. Open the page for the tide gauge in Manila's harbor, in the Philippines (sealevel.nasa.gov/ipcc-ar6-sea-level-projection-tool?psmsl_id=145) and click "Continue". A local table has two rows the global one doesn't: "Sterodynamic Sea Level" (the ocean swelling as it warms, plus changes in winds and currents that pile water higher along some coasts) and "Vertical Land Motion" (the land itself sinking, a positive number, or rising, a negative one). Write down the same numbers as in step 2, and the vertical land motion in 2100.
- Your coast. Click "Return to map". Click the magnifying glass at the bottom right and type the name of a coastal city: the one nearest your home, or one you care about. Choose its tide gauge. (You can also click a blue dot on the map; a numbered circle is a group of gauges close together: click it to split it.) Write down the same numbers. Then find "Projected Timing of Sea Level Rise Milestones", set to 0.5 m: each circle marks the year by which the sea is expected to have risen half a meter there. Read that year for SSP1-2.6 and SSP3-7.0.
- See it on a map. NOAA's Sea Level Rise Viewer (coast.noaa.gov/slr) maps US coasts only, and runs on computers and tablets, not phones. If your gauge in step 4 isn't in the US, use Charleston, South Carolina. Close any "Data Updates" box and click "Get Started". The panel that opens says what the water level is measured from: read it, then close it. Switch "Units", at the bottom of the slider, to meters. Type your city in the search box at the top. Drag the "Water Level" slider up to your gauge's SSP3-7.0 total for 2100, rounded to the nearest step. Blue is sea, deeper where darker; green is low land that may flood but isn't connected to the sea on the map.
What to hand in
- Four short answers: Q1 to Q4.
- One paragraph: Q5.
The questions
- Q1.
Report the world's rise in 2100 and 2150 under SSP1-2.6 and SSP3-7.0, and the largest single part of the rise in 2100 under SSP3-7.0. Then compare your 2100 numbers with Figure 8.10, which gives about 0.60 m for SSP1-2.6 and 0.84 m for SSP3-7.0. Why are the book's numbers bigger?
(3 points)
- Q2.
Report Manila's rise in 2100 under SSP1-2.6 and SSP3-7.0, and its vertical land motion. Why is Manila's rise so much bigger than the world's? Does the choice between the two scenarios change the vertical land motion? Use Figure 8.12 to say what the rise means for the Philippines.
(3 points)
- Q3.
Name your gauge. Report its rise in 2100 and 2150 under SSP1-2.6 and SSP3-7.0, its largest single part in 2100 under SSP3-7.0, its vertical land motion, and the years by which it reaches 0.5 m in the two scenarios. Figure 8.11 shows what half a meter can do to a flood that used to come once a century. What does it suggest for your coast?
(3 points)
- Q4.
The tool stops in 2150, but the sea won't. Use the rates from step 2 to show that the rise isn't slowing down by 2100 under SSP3-7.0. How does SSP1-2.6 differ? Why does the rise go on for centuries? What does the "SSP5-8.5 Low Confidence" column add?
(3 points)
- Q5.
In one paragraph, describe what NOAA's map shows at your 2100 water level: which places are under water, and what the water level is measured from. Then explain why the map understates the danger, using what section 8.6 says about storms, and name one way a city could respond.
(3 points)